DAELIM BESBI SC125 - Service Manual - Brake Caliper
14-4
BRAKE SYSTEM
BRAKE CALIPER
REMOVAL
Drain the brake fluid.
Remove the brake tube bolt.
Remove the flange bolt securing the caliper and
remove front axle.
CAUTION
Pay attention not to let the brake fluid adhere to the
parts because it can damage the painted surface.
Wind the hose joint with cloth to prevent the brake
fluid from leaking.
Clean the removed parts with the brake fluid and
make sure that the each port isn’t clogged with the
compressed air.
Keep the removed parts in order to avoid dust from
adhering.
DISASSEMBLY
Remove the slide pin, caliper bracket, pad spring, the
boot from the caliper.
If there is any wear or damage in the boot, replace it
with a new one.
Wind the caliper with cloth to prevent the piston or
brake fluid from leaking.
Remove the piston from the caliper while blowing the
low-pressure air in the opening of the brake hose.
CAUTION
Never use the high-pressure air or bring the air gun
too close.
Never touch the inside of the caliper
Disassemble the piston seal and the dust seal
NOTE
Pay attention not to damage the inner surface of the
caliper.
Clean the piston and the inside of the caliper and
remove the oil from the seal groove.