DAELIM BESBI SC125 - Service Manual - page 73
CLUTCH / DRIVEN PULLEY INSPECTION
Driven Face Bearing Inspection
Check the inner bearing oil seal (if installed) for
damage; replace as necessary.
Check the needle bearing for damage or excessive play
and replace as necessary.
Turn the inner race of the outer bearing with your
finger. Check that the bearing turns smoothly and
quietly, and that the bearing outer race fits securely.
Replace the bearing if necessary.
Movable Driven Face Spring Inspection
Measure the free length of the driven pulley spring and
replace if the service limit is exceeded.
SERVICE LIMIT : 163.7mm
TOOL : VERNIER CALIPER
Clutch Outer
Measure the I.D. at shoe contact surface of the clutch
outer. Replace the outer if the service limit is exceeded.
SERVICE LIMIT : 125.5mm
Clutch Shoe Inspection
Measure the thickness of each shoe ; replace if the
service limit is exceeded.
SERVICE LIMIT : 1.5mm
7-13
LH. CRANKCASE COVER/KICK STARTER/CONTINUOUSLY VARIABLE TRANSMISSION