DAELIM BESBI SC125 - Service Manual - Master Cylinder
14-6
BRAKE SYSTEM
INSTALLATION
Install the frontcaliper between the front fork and front
axle.
Tighten the caliper fixing bolts to the speciped torgue.
TORQUE VALUE : 3.0 kgf m
Install the brake hose to the caliper body with the 2
new oil bolt washer and oil bolt.
Tighten the oil bolt to the specified torgue.
TORQUE VALUE: 3.4 kgf m
Fill the brake fluid, and bleed air. (
14-2 )
MASTER CYLINDER
REMOVAL
Handle cover.
Drain the brake fluid.
Disconnect the front brake switch wire.
Brake tube bolt.
Master cylinder holder bolt.
Master cylinder .
CAUTION
Brake fluid causes damage to the painted, plastic or
rubber parts. Do not spill fluid on these parts.
If contaminated, gently wipe off the fluid with a
piece of cloth or wash in water. Close hose joints
properly to prevent leakage of brake fluid.
Clean the disassembled parts with brake fluid, and
use compressed air to verify each passage is not
clogged.
Do not allow the disassembled parts to be
contaminated by waste material or dust.
DISASSEMBLY
Remove the front stop switches.
Remove the boot, cir clip from the master cylinder.
TOOL : SNAP RING PLIERS