DAELIM BESBI SC125 - Service Manual - Rh. Crankcase Cover
8-4
A.C GENERATOR / STARTER CLUTCH
A.C GENERATOR INSTALLTION
Install the stator to the RH. crankcase cover.
Clean the tapered portion of the crankshaft.
Clean the inside part of the flywheel.
Check the woodruff key, install the flywheel by
aligning the groove with the woodruff key.
Temporarily install the flywheel nut, hold the flywheel
with the universal holder, and tighten the flywheel nut
with the specified torque.
TORQUE VALUE : 5.0 - 6.0 kgf m
TOOL : UNIVERSAL HOLDER
If the universal holder cannot be used, remove the LH.
crankcase cover and hold the drive face with the drive
face holder.
TORQUE VALUE : 0.8 - 1.2 kgf m
TOOL : DRIVE FACE HOLDER
Install the cooling fan .
Connect the A.C.G wiring coupler and connector to the
wire harness, and install the wiring with the clamp.
Install the muffer.
RH. CRANKCASE COVER
REMOVAL
Remove the following parts.
EX. muffler
Cooling fan cover
Cooling fan
A.C Generator
Loosen the crankcase cover setting bolt.
Remove the RH. crank case cover.