DAELIM BESBI SC125 - Service Manual - Headlight
18-2
LIGHTS/METER/SWITCHES
HEADLIGHT
REMOVAL
Remove the front cover.
Disconnect the headlight.
Remove the headlight coupler.
Remove the valve socket from the rubber booth.
Remove the rubber booth.
Remove the bulb.
NOTE
Before replacing the bulb, be sure to check the
switches for loose connection of the connectors.
If you touch the bulb with your bare hands, clean it
with a cloth moistened with denatured alcohol to
prevent early bulb failure.
Avoid touching Halogen headlight bulb. Finger
prints can create hot spots that cause a bulb to break.
Be sure to install the dust cover after replacing the
bulb.
WARNING
Headlight bulbs become very hot while the headlight
is ON, and remain hot for a while after they are
turned OFF. Be sure to turn the ignition switch OFF
and let the bulb cool down before replacement.
FRONT WINKER BULB
REPLACEMENT
Remove the upper handle cover.
Replace the blub.
TAIL LIGHT /REAR WINKER
BULB REPLACEMENT
Remove the body cover and tail light.
Replace the tail light lens as a set, it is LED.
Replace with a bulb, after remove the winker lens.
Install in the reverse order of removal.
NOTE
Pay attention not to damage the lens.
Do not apply excessive force when removing the lens.