DAELIM BESBI SC125 - Service Manual - page 51
5-7
FUEL SYSTEM
FLOAT CHAMBER/FLOAT/JET
ASSEMBLY
Install the needle jet, main jet holder, main jet and slow
jet.
Install the pilot screw O-ring washer, spring screw.
FLOAT LEVEL INSPECTION
Measure the float level with the float level gauge.
FLOAT LEVEL : 11 mm
TOOL : FLOAT LEVEL GAUGE
Install the float valve, float, float pin(4).
If the level is out of specification and the float arm lip
can be bent, adjust the float level by bending the lip.
Non-adjustable floats must be replaced.
NOTE
Be sure to keep the float level at the specified height.
If the float level is low / high, fuel mixture becomes
lean / rich.
Install the float body assembly, install the bracket and 4
pan screws.
NOTE
Be sure to replace the float chamber body O-ring
with the new one.
Insert the jet needle, needle spring holder, needle
spring, diaphragm assembly, and install the needle
screw.
NOTE
Install the jet needle aligned with the grooves in the
diaphragm.
Install the diaphragm assembly on the carburetor body.
Install the diaphragm spring.
Install the diaphragm cover with its cutout aligned with
the hole in the tab of diaphragm.