DAELIM VJF125 Service Manual - page 10

1-7

GENERAL INFORMATION

•Wire band must be secured firmly in the specified

location of the frame. In case of aluminium band,

secure the wire harness to the coated part.

•Secure the wire harness firmly using the clamp.

•Insert the connector until the vinyl cover is fully

inserted into the terminal.

•The opening of the vinyl cover must face at the ground

direction but in case of the plain connector, the draining

opening must face at the sky direction.

•When removing T-start, broaden the groove of T-start

using the wiring driver and release the torque.

•Connect the harness and the hose to T-start and then

insert until the groove is locked.

•When removing T-start from the frame, replace it with

the new one.

•In case of the weld clamp, do not clamp in the welded

part.

•When clamping the wire harness, make sure that the

harness is not contacted with the shaft or rotating part.

•When clamping the wire, pay attention not to contact

with hot part.

•The wire harness must be routed without contacting

with the end of the lamp or any sharp edge.

•The wire harness must be routed without contacting

with the end of the bolt or the piece.

WIRING DRIVER

DRAINING HOLE

GROOVE SIDE