DAELIM VJF125 Service Manual - page 158
PISTON / CYLINDER ASSEMBLY
PISTON RING ASSEMBLY
Clean the piston ring grooves and insert the piston
rings.
After installation, the rings should rotate freely in the
ring grooves.
PISTON / CYLINDER INSTALLATION
Remove gasket on the crank case surface.
11-5
CYLINDER / PISTON
Be careful not to damage the piston and rings during
assembly.
Do not confuse the top and second rings.
Space the ring end gaps 120 degrees apart.
Install the ring forward to the marking facing up.
Do not accord the side rail of oil ring
Place a clean shop towel over the crankcase to prevent
the clip from falling into the crankcase.
Do not damage the contact place of gasket
TOP RIDNG
SECOND RING
Insert the piston and piston into the conrod
Install new piston pin clips.
“IN”MARK, it does toward to intake side.
Take care not to drop the piston pin clip into the
crankcase.
Do not align the clip’s end gap with the piston
cutout.
TOP RING
WHITE PAINTING
SECOND RING
MARK
SIDE RAIL
SPACER
OIL RING
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
PISTON PIN CLIP
SIDE RAIL