DAELIM VJF125 Service Manual - Winker Relay

20-8

LIGHTS/SWITCHES/HORN

WINKER RELAY

Remove the rear seat. (⇨

13-2

)

Check the following:

- Battery condition

- Burned bulbs

- Burned fuse

- Main switch and winker switch function

- Loose connectors

If the above items are all normal, check the following:

1. Short the Black and Gray terminals of the winker relay

connector with a jumper wire.

Start the engine and check the winker light by

turning the switch to ON.

Light comes on 

Light does not come on

•Faulty winker relay

•Poor connection of the connector

•Broken wire harness

GEAR CHANGE SWITCH

Remove the seat. (13-2)

Remove the LH. side cover. (13-2)

Disconnect the neutral switch connector from the

switch.

Shift the transmission into neutral and check for

continuity between the green/white wire terminal and

ground.

There should be continuity with the transmission is in

neutral, and no continuity when the transmission is into

gear.

HORN

Disconnect the wire connectors from the horn.

Connect the 12V battery to the horn terminal directly.

The horn is normal if it sounds when the 12V battery is

connected acress the horn terminals.