DAELIM VJF125 Service Manual - page 260

19-5

ELECTRIC STARTER

Check for continuity between the cable terminal

and the case.

There should be no continuity.

Inspect the brushes for damage and measure the

brush length.

SERVICE LIMIT : 5 mm

Install the following :

- New O-ring

- Insulators

- Washer

- Washer nut

Install the brushes into the brush holder.

Install the brush holder into the motor case,

aligning the holder tab with the motor case groove.

Install the armature in the motor case, while

pushing in the brushes into the brush holder.

When installing the armature into the motor case,

hold the armature tightly to keep the magnet of the

case from pulling the armature against it.

Install the two washers.

Install a new seal ring onto the motor case.

Apply thin coat of grease to the armature shaft end.

Install the rear cover, aligning its mark with the

motor case mark.

•The coil may be damaged if the magnet pulls the

armature against the case.