DAELIM VJF125 Service Manual - page 9

1-6

GENERAL INFORMATION

•Insert the lock of the coupler until the lock is fully

secured.

•Turn off the main switch before connecting/dis-

connecting.

•Release the lock to disconnect the lock of the coupler.

•The lock of the coupler has two types according to

releasing method(press type and pull type) so release it

properly according to the shape.

- Typical releasing method of the coupler is illustrated in

the following.

•When disconnecting the coupler, disconnect it while

holding the coupler body. Pull while holding the wire

harness cord and do not remove the coupler connection.

•Release the lock by inserting the coupler slightly and

then narrowing connection to remove the coupler.

•Pay attention not to damage the vinyl cover of the

coupler.

•Check to see if there is bended terminal and secure it to

avoid disconnecting.

•If the wire harness coating is damaged, repair by

winding vinyl tape or replace it.

•Prior to connecting the connector, make sure that the

cover is not damaged and the mess terminal is not

opened.