DAELIM VJF125 Service Manual - page 235
16-18
HYDRAULIC BRAKE
DISASSEMBLY
Remove the pad spring, slide pin, caliper bracket and
boot from the caliper body.
If there is any wear or damage in the boot, replace it
with a new one.
Install corrugated cardboard or soft wood sheet
between the pistons.
Apply small squirts of air pressure to the brake hose
assembly part to remove the pistons from the caliper.
INSPECTION
Check the caliper friction surface for damage or
scratches.
Measure the caliper I. D.
SERVICE LIMIT : 25.07mm
Remove the piston seal and dust seal.
Clean the caliper inside and piston with brake fluid.
Do not use high pressure air or bring the air gun too
close.
Do not touch the inside of caliper.
Avoid spilling fluid on painted, plastic, or rubber
parts.
Keep oil off the brake disk or pad, because the
contaminated brake disk or pads reduce the braking
performance if contaminated.
Replace the pad with a new one and clean the disk.
Be careful not to damage the caliper inside.
PISTON SEAL
PISTON SEAL
PISTON SEAL
PISTON SEAL
PISTON SEAL
PISTON SEAL
PISTON SEAL
PISTON SEAL
PISTON SEAL
PISTON SEAL
PISTON SEAL
PISTON SEAL
PISTON SEAL
PISTON SEAL
PISTON SEAL
PISTON SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL
DUST SEAL