DAELIM VJF125 Service Manual - Crankshaft Installation
12-8
CRANKCASE/TRANSMISSION/CRANKSHAFT
RH. Crank Case
Remove the main shaft bearing set plate.
Remove the main shaft bearing, counter shaft
bearing and crank shaft bearing from crankcase.
Apply the new bearing with clean engine oil and
install it into crankcase.
Insert closely the cooling jet into crankcase.
- Insert angle: 10
2
TOOLS :
MAIN SHAFT / COUNTER SHAFT / CRANK
BALANCER SHAFT BEARING
- DRIVER
- ATTACHMENT
- PILOT
Coat the socket bolt screw part with oil and install
the main shaft bearing set plate.
TORQUE : 1.2kgf
·
·
m (12N
·
·
m)
CRANKSHAFT INSTALLATION
Coat a new left crankshaft bearing with clean
engine oil and install new bearings into the right
crankcase.
TOOLS : DRIVER
ATTACHMENT
PILOT
Install the crankshaft into the RH. crankcase with
the following tools:
TOOLS : ASSEMBLY SHAFT
CRANKSHAFT ASSEMBLY COLLAR
CRANK SHAFT
CRANK ASSEMBLY