Lantronix MPS1-2 Installation Manual - page 17

TCP/IP Configuration

4 - 3

C.

The subnet, if you wish to use a subnet other than the default.

D. The IP address of the TFTP server you wish to use, if desired.

4.

Click 

OK

.

5.

Cycle power on the server. EZWebCon will let you know whether the conÞgura-

tion was successful.

4.1.2 Using a Directed Ping Packet

The ARP/ping method is available under UNIX, Windows 95, and Windows NT. If the 

MPS has no IP address, it will set its address from the Þrst directed IP packet it receives. 

NOTE:

The ARP/ping method only works during the first two minutes of 

MPS operation. After two minutes, an alternate method must be used 

or the MPS must be rebooted.

On a 

UNIX

 host, create an entry in the hostÕs ARP table and substitute the intended IP 

address and the hardware address of the server, then ping the server. This process 

typically requires superuser privileges.

# arp -s 192.0.1.228 00:80:a3:xx:xx:xx

% ping 192.0.1.228