Lantronix MPS1-2 Installation Manual - page 77

Updating Software

D - 7

IP address, hardware address, and download path and Þlename to the appropriate host 

Þle (usually /etc/bootptab).

Some BOOTP and TFTP implementations require a speciÞc directory for the MPS.SYS 

Þle; in this case the path should not be speciÞed in the bootptab Þle and the Þle must be 

placed in that directory. See your hostÕs documentation for instructions on how to 

conÞgure the MPS.SYS Þle in the directory.

If BOOTP cannot be used to conÞgure the Server's IP parameters, conÞgure them by 

hand using the following commands listed below.

NOTE:

For instructions on how to log into the Server and enter these commands, 

refer to Chapter 6, TCP/IP Configuration.

Local> SET PRIVILEGED

Password> SYSTEM (not echoed)

Local>> DEFINE SERVER IPADDRESS nnn.nnn.nnn.nnn

Local>> DEFINE SERVER SOFTWARE “/tftpboot/ MPS.SYS”

Local>> DEFINE SERVER LOADHOST nnn.nnn.nnn.nnn

Local>> LIST SERVER BOOT

Local>> INITIALIZE RELOAD