Lantronix MPS1-2 Installation Manual - 6 - Lat Configuration

LAT Configuration

6 - 1

6 - LAT Configuration

The EZWebCon conÞguration software is the easiest way to conÞgure the MPS. The 

following sections cover print conÞguration methods for LAT hosts.

NOTE:

The Server needs an IP address before you can use EZWebCon. See 

the Setting the IP Address section on page 4-2 for instructions.

LAT print queues can be created by printing to a port or printing to a service. Printing 

directly to a port requires no MPS conÞguration. 

NOTE:

Printing directly to a port is the easiest method for printing to the 

MPS. If you would like instructions for printing to a service, see the 

Print Server Reference Manual on the CD-ROM.

6.1 Printing Directly to a Port

1.

Create a LAT application port that references the Server port. 

$ RUN SYS$SYSTEM:LATCP

LATCP> CREATE PORT LTAnnn/APPLICATION

LATCP> SET PORT LTAnnn/NODE=MPS_xxxxxx/PORT=Port_n

LATCP> EXIT