Lantronix MPS1-2 Installation Manual - page 75

Updating Software

D - 5

¥ DeÞne commands must be used because Set conÞgurations are 

cleared when the Server boots. Use the List Server Boot command 

to check settings before rebooting.

NOTE:

It is very important to check the Server settings before using the Initialize 

Reload command to ensure that you are reloading the correct software file.

D.4.1 Reloading Sequence

If DHCP, BOOTP, or RARP is enabled on the Server, the Server will request assistance 

from a DHCP, BOOTP, or RARP server before starting the download attempts. The 

Server will then try TFTP, NetWare, and MOP booting, in that order, provided that it has 

enough information to try each download method.

Downloading and rewriting the Flash ROM will take approximately two minutes from 

the time the Initialize command is issued. If the download Þle cannot be found or 

accessed, the Server can be rebooted with the code still in Flash ROM. As noted in 

Chapter 2, the OK/ACT LED will blink quickly while the Server is booting (and 

reloading code) and then slowly when it returns to normal operation.

NOTE:

If you experience problems reloading Flash ROM, refer to Troubleshooting 

Flash ROM Updates on page D-9.