Lantronix MPS1-2 Installation Manual - 7.2 Macintosh Services

AppleTalk Configuration

7 - 2

7.2 Macintosh Services

Before attempting to print from a Macintosh, ensure that AppleTalk and PostScript are 

both enabled on at least one service. Once the service is conÞgured, it will appear in the 

Chooser in the same zone as the MPS. Select the service in the Chooser and complete the 

appropriate setup options. Then close the Chooser window and print a test page of text 

to the Macintosh service.

7.3 AppleTalk Zones

If there is a router on the network, the MPS will appear in the default zone speciÞed by 

the router. To change the default zone use the DeÞne Protocol AppleTalk Zone 

command. 

If the MPS is attached to a network without an AppleTalk router, all AppleTalk devices 

(including the MPS) will appear in the default zone in the Chooser.

NOTE:

If no router is present on the network, the MPS will not accept AppleTalk 

print jobs for 60 seconds after booting.