Lathem FR700 User Manual - Install The Facein Terminal

P A Y C L O C K   &   F A C E I N   U S E R ’ S   G U I D E  

8

Install the FaceIN Terminal 

Step 1:

 Select a site to install your FaceIN terminal that will be 

convenient to employees clocking in and out. When deciding where 

the terminal will be installed, keep in mind that an 115vAC power 

outlet should be within 6 feet of the mounting location as well as a 

connection to the network (LAN). 

Note about Direct Sunlight - 

It is not recommended to have the 

terminal mounted in a location where it is exposed to direct sunlight. 

This could be troublesome during the registration process. 

Step 2:

 After selecting the appropriate installation site, use the 

terminal to determine the appropriate height. Have the shortest 

employee stand in from of the terminal. Hold the terminal on the 

wall so that this employee can comfortably center their face in the 

LCD display window. Mark the height of the terminal on the wall. 

Note:

 Taller employees can easily adjust their stance to center their 

face in the LCD display window. 

Install the mounting-plate to the wall using the supplied screws. For 

sheetrock walls, drill a 3/16” diameter hole through each of the four 

screw locations; each approx 1-1/2” deep. Install the plastic 

“anchors” included in the mounting screw packet.