NEC Univerge SV8100 Quick Manual
NEC
SV8100 Quick Guide
Handset Layout
Soft Touch Keys
The NEC handsets have menus that can be accessed by
pressing the buttons below the LCD screen. There are 4 soft
touch keys that change depending on the mode you are in.
Line Keys / DSS Keys
The top line is programmed as “Line Keys” they shows lines
4 & 5 are in use. The bottom line is programmed as Direct
Station Select (DSS) keys in this example Joel’s extension is
busy.
Navigation / Scroll Keys
Used for:
o
Speed dials.
o
Inbound call register.
o
Outbound call register.
o
Volume control.
Making Outside Calls
o
Lift handset.
o
Dial 0.
o
Dial telephone number.
Put a call on Hold
o
Press the Hold key during a call.
o
Outside calls will flash on the Line key.
o
Press the flashing key to retrieve the held call.
Transferring a Call
Without DSS keys
Method 1. ( Blind transfer )
o
Press the Transfer Key during a call.
o
Dial the required extension number.
o
Hang up to send the call through.
Method 2 ( Announced transferred )
o
Press the Transfer Key during a call.
o
Dial the required extension number.
o
Wait for answer, announce the call.
o
Hang up to send the call through.
o
or select green flashing line if called party does not
want to take the call.
With DSS keys
Method 1 (Blind transfer)
o
Press the DSS key during a call.
o
Hang up to send the call through.
Method 2 (Announced transferred)
o
Press the DSS key during a call.
o
Wait for answer, announce the call.
o
Hang up to send the call through.
o
or select green flashing line if called party does not
want to take the call.
www.phonehelp.com.au