Samlexpower Evolution EVO-2212 Owner's Manual - page 24
24 | SAMLEX AMERICA INC.
SECTION 2 |
Components & Layout
12
13
11
10A
10B
10C
1
3
4
Protection Covers for Battery Terminals
8
5
2
1a Red
1b Black
9A
14
15
16
9B
9C
6
9D
7
1. Battery Positive (+) Input Connector – M10 x 1.25 Nut & Bolt (RED Protection Cover 1(a) is Removed)
1a. RED Protection Cover For Battery Positive (+) Input Connector
2. Battery Negative (-) Input Connector – M10 x 1.25 Nut & Bolt (Black Protection Cover 1(b) is Removed)
2a. Black Protection Cover for Battery Negative (-) Input Connector
3. External Charger (+) Input Connector – M12 x 0.75 Thumb Nut and Bolt
4. External Charger (-) Input Connector - M12 x 0.75 Thumb Nut and Bolt
5. DC Side Ground Connector – Hole Dia 6.5mm for AWG #4 to #6. Set Screw M-8
6. RJ-45 Jack for Temperature Sensor “EVO-BCTS” (Fig. 2.5)
7. RJ-45 Jack for EVO-RC Remote
8. Air inlet vents for 2 internal cooling fans [Additional air inlet vents at the bottom (not shown)]
9A, 9B. RJ-45 Jacks for Communication Ports “COMM 1” and “COMM 2” - For RS-485 networking and
MODBUS Serial Communication Protocol (for future use)
9C, 9D. RJ-45 Jacks for Communication Ports “COM 3” and “COM 4” - For “CANbus” Serial Communi-
cation Protocol (for future use)
10A to 10C. Knock outs for AC wiring inlet/exit wiring entry (Diameter: 27.8mm / 1 3/32”) (For ¾”
conduit/fittings)
11. ON/OFF Push Button
12. Green LED “ON”
13. Red LED “Fault”
14. Output Terminals for Status Relay - Screw M 2.5; AWG #30 to #12
15. +12V Input Terminals for “Remote On Off” (9 to 15V, 3mA) - Screw M 2.5; AWG #30 to #12
16. Output Terminals for +12VDC source (up to 100mA) (available only when unit is ON) - Screw M 2.5;
AWG #30 to #12
Fig 2.1 Layout-Front
2.
1 MAIN UNIT: LAYOUT-FRONT (FIG 2.1)