Tally T6090 Maintenace Manual - Figure Listing
T6090 Maintenance Manual
6
Figure Listing
Chapter 4
Figure 4–1.
Disconnecting the Gas Spring .................................................................................... 4–2
Figure 4–2.
Removing the Lid ....................................................................................................... 4–3
Figure 4–3.
Removing the Control Panel ...................................................................................... 4–4
Figure 4–4.
Reinstalling the Control Panel ................................................................................... 4–5
Figure 4–5.
Removing the Right End Cover ................................................................................. 4–6
Figure 4–6.
Reinstalling the Right End Cover .............................................................................. 4–7
Figure 4–7.
Removing the Engine Controller CBA ...................................................................... 4–8
Figure 4–8.
Removing the Personality Module CBA ................................................................. 4–10
Figure 4–9.
Removing the Personality Module Enclosure ......................................................... 4–11
Figure 4–10.
Removing the Fan Assembly. ................................................................................... 4–12
Figure 4–11.
Disconnecting the Static Ground. and Removing the Sound Deadening Hood ...... 4–13
Figure 4–12.
Removing the Power Supply .................................................................................... 4–14
Figure 4–13.
Removing the Left End Cover ................................................................................. 4–15
Figure 4–14.
Disconnecting the Ribbon Platform Components ................................................... 4–16
Figure 4–15.
Removing the Ribbon Platform ............................................................................... 4–17
Figure 4–16.
Removing the Ribbon Motor ................................................................................... 4–18
Figure 4–17.
Disconnecting the Hammer Bank ............................................................................ 4–19
Figure 4–18.
Removing the Hammer Bank ................................................................................... 4–20
Figure 4–19.
Removing the Ribbon Shield ................................................................................... 4–21
Figure 4–20.
Removing Hammer Bank Air Duct .......................................................................... 4–23
Figure 4–21.
Removing and Replacing the Hammer Module. ..................................................... 4–24
Figure 4–22.
Using the Hammer Alignment Tool ......................................................................... 4–25
Figure 4–23.
Shuttle Assembly Removal ...................................................................................... 4–26
Figure 4–24.
Removing the Platen ................................................................................................ 4–27
Figure 4–25.
Platen End Assembies .............................................................................................. 4–28
Figure 4–26.
Removing the Platen Open Sensor .......................................................................... 4–29
Figure 4–27.
Removing the Shuttle Motor .................................................................................... 4–30
Figure 4–28.
Reinstalling Shuttle Motor Pulley ............................................................................ 4–31
Figure 4–29.
Removing the Shuttle Motion/Capture Sensor ........................................................ 4–32
Figure 4–30.
The Shuttle Drive Belt .............................................................................................. 4–34
Figure 4–31.
Removing the Paper Drive Motor ............................................................................ 4–35
Figure 4–32.
Paper Advance Motor Assembly .............................................................................. 4–36
Figure 4–33.
Phasing/Belt Adjustments ........................................................................................ 4–37
Figure 4–34.
Phasing Gauge Installation ...................................................................................... 4–37
Figure 4–35.
Paper Drive Belt Adjustment ................................................................................... 4–38
Figure 4–36.
Removing Upper Tractor Assembly ......................................................................... 4–39
Figure 4–37.
Upper Tractor Alignment ......................................................................................... 4–40
Figure 4–38.
Removing Lower Tractor Assembly ........................................................................ 4–41
Figure 4–39.
Lower Tractor Alignment ......................................................................................... 4–42
Figure 4–40.
Platen Gap Adjustment ............................................................................................. 4–43