Tally T6090 Maintenace Manual - page 98

T6090 Maintenance Manual

4–28

Reinstalling

STEP 1.

Reconnect the Platen Open Sensor to the Platen.

It is possible that the end assemblies of the platen may come off of the platen when you

remove it.  When you reassemble the platen make sure ALL parts are included.  Some

parts are small (for example, the spring washers on the right end of the platen) and are

easily lost.  Refer to the figure below to identify the parts and the installation sequence.

Platen

Platen Open

Sensor

Form

Thickness

Lever

Platen 

Adjust

 Plate

Curved Spring

 Washers

Platen Adjust Plate

Platen - Right End

Platen - Left End

Figure 4–25.  Platen End Assemblies

STEP 2.

Place the springs back on the ends of the platen and secure it in place.

STEP 3.

Reinstall the Hammer Bank.

Before you reinstall the Ribbon Platform, check the hammer to platen gap and adjust as

necessary (see Procedure 25).

After completing the installation, perform a Hammer Calibration to maintain optimum print

quality (see PrntCal Parameter in Chapter 2).