Tally T6090 Maintenace Manual - page 102
T6090 Maintenance Manual
4–32
Procedure 19 — Shuttle Motion Sensor
The Shuttle Motion Sensor is mounted on the bracket behind the lower Shuttle Gear.
Removing
STEP 1.
Remove Right End Cover (see Procedure 3).
STEP 2.
Using a #1 Phillips stubby screwdriver, loosen the screw securing the sensor.
STEP 3.
Lift sensor over loosened screw, disconnect sensor cable from Engine Controller CBA (J604),
and remove the ferrite bead encircling the group of cables atop the Engine Controller CBA.
J604
Shuttle
Sensor
Figure 4-29. Removing the Shuttle Motion/Capture Sensor
Reinstalling
STEP 1.
Mount the sensor on the bracket behind the lower Shuttle gear. Do not tighten screw yet;
you’ll need the sensor loose to adjust it.
The sensor position should not interfere with rotation of Shuttle.
STEP 2.
Connect the sensor cable into Engine Controller CBA (J604), reinstall the ferrite bead around
the cables, then perform the adjustment procedure that follows to set up correct sensing levels.