Tally T6090 Maintenace Manual - page 85
Chapter 4: Removal and Reinstallation Procedures
4 –15
Procedure 8 – The Left End Cover
Before beginning this procedure, turn the printer off and disconnect the power cable.
Removing
STEP 1.
Remove the printer lid (see Procedure 1).
STEP 2.
Remove the screws in locations 1 and 2.
STEP 3.
Loosen the screws in locations 3, 4, and 5 . On pedestal models, the screw in position 5 can
only be accessed if the pedestal door is partially open.
4.
5.
3.
2.
1.
Figure 4–13. Removing the Left End Cover
STEP 4.
Lift up on the end cover until it clears the printer and can be removed.
Reinstalling
STEP 1.
Align the lip of the cover with the lip on the printer just above screw location 5, then insert the
lip around the base of the cover into the mounting channel on the printer.
STEP 2.
Press down on the cover until it seats in the channel.
STEP 3.
Reinstall the screws at locations 1 and 2.
STEP 4.
Tighten the screws at locations 3, 4, and 5.
STEP 5.
Reinstall the printer lid.