Tally T6090 Maintenace Manual - page 76
T6090 Maintenance Manual
4–6
Procedure 3 – The Right End Cover
Before beginning this procedure, turn the printer off and disconnect the power cable.
Removing
STEP 1.
Remove the Printer Control Panel. (See Procedure 2)
STEP 2.
Remove the screws at positions 1 and 2.
STEP 3.
Loosen the screws at positions 3, 4, and 5.
STEP 4.
Pull up on the front edge of the cover until it comes free of the channel it sits in. When the
front edge comes free you can lift straight up on the cover and remove it from the printer.
Step 2.
Remove 2 Screws
Step 4.
Step 3.
Loosen Screws
1.
2.
3.
5.
4.
Figure 4–5. Removing the Right End Cover
Reinstalling
STEP 1.
Make sure that all connections are secure and all cables are kept away from the areas where
the cover contacts the printer.
STEP 2.
Set the end cover over the Engine Controller CBA and Shuttle. Align the short lip on the front
inside edge of the cover over the lip (1) on the printer and the channel in front (2) and side (3)
of the printer.