Tally T6090 Maintenace Manual - page 50
T6090 Maintenance Manual
3–4
Table 3–1, Continued
MESSAGE
Explanation and Corrective Action
Fatal Fault n
Explanation:
A fault has been detected in the software.
Corrective Action:
Cycle power and try again. If this does not clear the problem, remove
and replace the Personality CBA. If it fails again, remove and replace
the Engine Controller CBA.
Flt Clr Timeout
Explanation:
The Main CPU cannot clear a fault in the Control CPU.
Corrective Action:
Remove and Replace the Engine Controller CBA.
Font Dnld Error
Explanation:
An error has been detected during a font download.
Corrective Action:
Correct data and retransmit from host.
Heap Overflow
Explanation:
Graphics memory space is full and the printer cannot accept or
process data. Printer will reset and data will be lost.
Corrective Action:
Insert line terminators in data stream so the printer will process the
data, then retransmit the data.
Link Fault (n)
Explanation:
This message indicates that data flow has been interrupted between
the main processor and the control processor.
If n = :
(0) Maximum Packet Length Exceeded
(1) Inter processor Link Transmit Timeout
(2) Illegal Packet Length
(3) Illegal Packet Type
(5) Inter processor Link Receive Timeout
(6) Sweep Done Timeout
(9) Inter processor Link Receive Overrun
(10) Status Request Timeout
(11) Temperature Request Timeout
Corrective Action:
Cycle printer power. If that does not clear the problem, download new
printer firmware.
Main CPU Fault
Explanation:
A fault has been detected in the main processor during powerup
diagnostics.
Corrective Action:
Remove and replace the Personality Module CBA.
No VFU Loaded
Explanation:
A VFU command was received from the host before a VFU was
Downloaded.
Corrective Action:
Download the required VFU information, then retransmit the data.
NVRAM Fault
Explanation:
The nonvolatile data checksum has failed because the variable values
have been altered in a destructive manner.
Corrective Action:
Depress the CLEAR Key. If the message does not clear, cycle printer
power. If the message still does not clear, remove and replace the
Engine Controller CBA.
Offline Data In
Explanation:
The printer is in Offline condition and nonprinted data is in the buffer.
Corrective Action:
There is no corrective action required. Under normal conditions the
printer will continue to print when it is placed back Online. If you do
not want the buffered data to print, enter the Clear Menu by depress-
ing the CLEAR Key before going back Online and select the Clear
Buffers entry to clear the buffered data.