Tally T6090 Maintenace Manual - page 33
2–3
Chapter 2: Menu Operations
Report Parameter (Menu Level 2)
This parameter has four selections. Two of the selections, Configs and CalData, generate
printouts. The second pair of reports (LastFlt and Version) are displays. The Report Param-
eter is located in the CONFIGuration Menu, under the Printer Category.
Report selections (Menu Level 3)
Configs
Prints a report showing the setups of the configurations.
CalData
Prints a report showing timing signals and voltage levels that govern certain basic
printer functions.
LastFlt
The Control Panel Display shows the Last Fault that occurred
Version
The Control Panel Display shows the version number of the currently installed
firmware.
To clear the displays, depress any key on the printer control panel.
Selecting a Printer Report
STEP 1. Take the printer Offline.
STEP 2. Depress the MODE Key to enter the multilevel menu system, then scroll (▲ Key) to
the CONFIG selection.
STEP 3. Depress the FORMS/1 Key to access the CONFIG Menu categories, then scroll
(▲ Key) until the Printer Category is displayed.
STEP 4. Depress the CPI/2 Key to access the Printer Category parameters, then scroll
(▲ Key) until the Report Parameter is displayed.
STEP 5. Depress the LPI/3 Key to access the Report selections, then scroll (▲ Key) to the
desired selection.
STEP 6. Depress the ENTER Key to begin the Report printout or display.