Tally T6090 Maintenace Manual - page 165
3
Supplement to Manual
080933
Reinstalling
STEP 1.
Install shim spacers underneath the
spares replacement modules as
appropriate. Two .0015" shim spacers
are included in each module kit
(#081152). After the screws for the
module are tightened, check the
height of the module for accuracy.
STEP 2.
Install the new Module on the
Hammer Bank. Be very careful
when installing the new module. The male prongs can be bent easily and may not
align properly when they are plugged in.
Depending on module height,
you may or may not need to add
shims.
Figure S–3. Checking Module Height
STEP 3.
Use the Hammer Alignment Tool (#080614 available in tool kit, #081147) to realign the
Hammers. Tighten the two mounting screws, then reinstall the Ribbon Shield.
6-Pack
Hammer
Modules
Hammer AllignmentTool
P/N 080614
Figure S–4. Using the Hammer Alignment Tool
Hammer Bank Carriage
Module
Mounting
Screws (2)
Shim
Spacer(s)
Hammer
Module
Figure S–2. Installing Shim Spacer
Add Shims
Remove Shims
Correct