Tally T6090 Maintenace Manual - page 88
T6090 Maintenance Manual
4–18
Procedure 10 – The Ribbon Motor
Before beginning this procedure, turn the printer off and disconnect the power cable.
Removing
STEP 1.
Remove the Ribbon Platform (see Procedure 9).
STEP 2.
Remove the panduit that secures the Ribbon Motor cable to the platform. The motor can now
be removed.
STEP 3.
Remove the four screws that secure the motor to the Ribbon Platform.
Ribbon Motor
J502
Figure 4–16. Removing the Ribbon Motor
Reinstalling
STEP 1.
Insert the motor shaft through the hole in the Ribbon Platform, then align the screw holes
(make sure that the motor cable is on the side toward the Control Panel) and reinstall the motor
mounting screws. Secure the Ribbon Motor cable to the platform with a panduit.
STEP 2.
Reinstall the Ribbon Platform.