Yamaha M7CL StageMix V1.5 Quick Start Manual - page 14
M7CL Quick Start Guide Part 2
14/20
MONITOR section. CUE buttons. Assigning a monitor output.
Cueing a channel will send its audio signal to the CUE bus and meter the channel in the Function Access Area.
The audio will be sent to the headphone output under the front panel. Press the [MONITOR] headphone symbol
to access options for the monitor setup.
Note; [CUE] > [SEL] link is in SETUP>USER SETUP.
By default, the MONITOR section is fed by
STEREO L/R and these signals are sent to
the headphone output. (Found under the
front panel.) Cueing a signal interrupts this
and replaces the cued signal.
As well as the headphones, the MONITOR
section can output via an OMNI socket on
the rear. This patching is also accessed
from the MONITOR pop-up.
Using the SOURCE SELECT buttons
in the MONITOR section can switch
off the default STEREO L/R feed to the
monitor bus or replace it with one of
the other outputs or a ST IN.
The PHONES LEVEL LINK makes the
headphone level control come after
the MONITOR LEVEL pot on the
surface. This link can be broken,
which is especially useful for monitor
mixing.
Press here for
cue clear.