Yamaha M7CL StageMix V1.5 Quick Start Manual - page 20
M7CL Quick Start Guide Part 2
20/20
Troubleshooting.
I can’t get +48V to work.
☞
+48V is switched on/off in the HA pop-up, but remember there is also a master switch on the SETUP
page. This is not covered by scene recall.
The aux sends are in big steps when I turn the encoder;
I need a finer control on my output delays;
☞
Try pushing and turning at the same time. This gives a fine resolution mode.
When I press the navigation keys, the screen changes but the faders don’t copy to the chosen bank.
☞
This is a feature often used to keep access to the DCA masters even when other banks are chosen. Press
and hold the navigation key until it flashes. Now that fader bank is locked even though the screen
information changes. To undo, just press and hold again.
I’ve recalled Scene 000 but some faders and other things have not reset to zero.
☞
Are there any recall safes set? This means that aspects of Scene 000 may not have been recalled because
they are safe from recall changes. Check in CH JOB > RECALL SAFE. Clear all of these and recall Scene
000 again.
The fader has stopped working!
☞
Is SENDS ON FADER active; this means you are pushing up an aux send and not the channel master. You
can tell easily when you are in sends on fader mode because all the green [SEL] indicators are on except
the selected channel. In normal mode, the [SEL] indicators are off and the selected channel is lit.
☞
Have you ‘moved’ a channel or changed the patch or both? Check the patch and the channel name/
number to confirm they are what you expect.
Where are the output delays?
☞
They are outport delays, found in the OUTPUT PORT pop-up via the SETUP page.
I’ve checked and checked all the settings and still the Studio Manager software says the ports are
unavailable! My colleagues computer connects fine.
☞
You need to use a CAT-5 crossover cable. Some computers detect and fix this problem automatically so
that’s why other computers work and yours doesn’t.
Where can I find out more information?
☞
You can download the manual from;
http://www.yamaha.co.jp/manual/english/result.php?div_code=pa&model=M7CL&cat_code=&div_code=pa