3Com OfficeConnect User Manual - page 26
2-6
C
HAPTER
2: C
REATING
Y
OUR
N
ETWORK
Using the Rubber Feet and Stacking Clips
The four self-adhesive rubber feet prevent your hub
from sliding around on your desk. Stick the feet to
the marked areas at each corner of the underside of
your switch.
The four stacking clips are used for neatly and
securely stacking your OfficeConnect units together.
To stack your units, secure the clips on one side and
then on the other.
You can stack up to a maximum of four units.
Large units must be stacked below small units.
Use the following method to secure one side:
1
Place your new unit on a flat surface. Your clips fit in
the positions on the side of the unit, as shown in
2
Position a clip over one of these holes and push it in
until it clicks into place, as shown in
Repeat this for the other clip position on the same
side.
3
Keeping the front of the units aligned, rest the
bottom of the existing unit on the clips’ spikes, as
shown in
(3). Push the clips firmly into the
existing unit until they click into place.
Figure 2-3
Clipping Your Units Together
Repeat these steps to secure the other side.
To remove a clip, hold the units firmly with one hand
and hook the first finger of your other hand around
the back of the clip. Use reasonable force to pull it
off.