3Com OfficeConnect User Manual - page 94
C-2
A
PPENDIX
C: S
ERIAL
W
EB
U
TILITY
4
In the Run dialog box, type
drive:\Win95\
Drivers\Slip\SETUP
(where
drive
is the letter of
your disk drive) and click OK.
The installation program starts and checks your
system configuration; enter any information that’s
requested.
If the setup program cannot find specific files on
your management station, it asks you to insert your
Windows ‘95 CD-ROM. If it still cannot find the files,
you must obtain them directly from Microsoft.
Contact Microsoft for more information.
5
When the installation program has ensured all the
relevant files are installed, it asks you to select the
COM port. This is the serial port on your management
station that you are going to use when connecting to
the switch’s console port.
If you click Advanced, the Advanced Configuration
Parameters dialog box is displayed, showing all of the
settings the serial web utility will use when it is run.
These default settings are already correct for
connection to the switch so you should not need to
change them.
The fields are:
Connection name Allows you to enter a name for
the connection.
Modem name Allows you to enter a name for the
modem connection.
PC SLIP Address The SLIP address that is to be
allocated to the management station. The default
address is ‘192.168.101.2’.
Device URL The URL that the serial web utility uses
to access the switch, which includes the switch’s SLIP
address. For example, the default SLIP address for the
switch is ‘192.168.101.1’ so the URL is:
http://192.168.101.1/
Flow Control None / XON/XOFF / Hardware RTS/CTS
Allows you to specify the flow control that the
management station is to use.
Data bits, Stop bits and Parity are all fixed.
Speed 1200 / 2400 / 4800 / 9600 / 19200
Allows you to specify the baud rate that the
management station is to use.
You also have the option of changing the PC SLIP
Address, Device URL, Flow Control and Speed after
the installation is complete.