3Com OfficeConnect User Manual - page 53
Unit Pages
4-15
Console Port Configuration
This page configures the console port.
The switch’s console port is already correctly
configured by default, for direct connection to a
management station. Only alter these default settings
if you are connecting a modem to the console port.
If you want to change the settings but are unsure of
the correct settings to use, refer to the user
documentation that accompanies your management
station or modem.
CAUTION:
Do not change any of these settings
unless you fully understand what you are doing.
Incorrect settings may lock you out from the switch’s
console port when you select Apply, and you may
have to contact your supplier for information on
recovering management communication if you
cannot access the switch over the network.
The fields are:
Console connection
Terminal / Modem
Specifies what you are connecting directly to the
console port. If you are connecting to a modem,
select Modem, otherwise leave as Terminal
(management station).
Port Speed
1200 / 2400 / 4800 / 9600 / 19200 /
AutoConfig
Specifies the baud rate of your management station
or modem. The switch can automatically configure its
baud rate to work with your management station or
modem. Leave this field as
AutoConfig
if you require
auto-configuration.
Flow Control
None / Xon/Xoff / Hardware RTS/CTS
Specifies the flow control option that corresponds to
your management station or modem.