4RF Aprisa SR+ User Manual - page 124
Managing the Radio | 121
Aprisa SR User Manual
Maintenance > Advanced
NETWORK
Node Registration Retry (sec)
This parameter sets the Base Station poll time at startup or the Remote / Repeater Station time between
retries until registered. The default setting is 10 seconds.
Base Station Announcement Period (min)
This parameter sets the period between Base Station polls post startup. The default setting is 1440
minutes.
When a new Base Station powers on, it announces its presence and each remote that receives the
announcement message will be advised that a new Base Station is present and that they should re-
register. This allows the new Base Station to populate its Network Table, with knowledge of the nodes in
the network.
If, during this initial period, there is some temporary path disturbance to one or more remotes, they may
miss the initial announcement messages and be left unaware of the Base Station change. For this reason,
the Base Station must periodically send out announcement messages to pick up any stray nodes and the
period of these messages is the Base Station Announcement Period.
Setting this parameter to 0 will stop further announcement messages being transmitted.
Node Missed Poll Count
This parameter sets the number of times the Base Station attempts to poll the FAN at startup or if a
duplicate IP is detected when a Remote / Repeater Station is replaced. The default setting is 3.