4RF Aprisa SR+ User Manual - page 75
72 | Managing the Radio
Aprisa SR User Manual
OPERATING SUMMARY
Operating Mode
This parameter displays the current operating Mode i.e. if the radio is operating as a Base Station,
Repeater Station or Remote Station.
Interface Mode
This parameter displays the Interfaces available for traffic on the radio (see ‘Maintenance > Licence’ on
page 120).
TX Frequency (MHz)
This parameter displays the current Transmit Frequency in MHz.
TX Power (dBm)
This parameter displays the current Transmit Power in dBm.
RX Frequency (MHz)
This parameter displays the current Receive Frequency in MHz.
Channel Width (kHz)
This parameter displays the current Channel Width in kHz.
Network ID (Field Area Network)
This parameter is the network ID of this Base Station node and its Remote / Repeater Stations in the FAN.
The entry is four hex chars (not case sensitive).
Node Address
The Node Address of the Base Station is 0000.
If the Node Address shown is FFFE, this radio is a Remote Station or Repeater Station but has not been
registered with the Base Station.
The Base Station will automatically allocate a Node Address to all its registered Repeater Station and
Remote Station radios. This address can be between 0001 and F000.
Network Radius
This parameter displays the maximum number of hops in this network.
Inband Management
This parameter displays the status of the Inband Management option.
Inband Management Timeout (sec)
This parameter displays the number of seconds that the Base Station waits for a response from a Remote
or Repeater Station before aborting the Inband Management request.