4RF Aprisa SR+ User Manual - page 57
54 | Installing the Radio
Aprisa SR User Manual
Connecting the Power Supply
The nominal input voltage for a radio is +13.8 VDC (negative earth) with an input voltage range of +10 to
+30 VDC. The maximum power input is 30 W.
The power connector required is a Phoenix Contact 4 pin female screw fitting part MC 1.5/ 4-STF-3.5.
This connector is supplied fitted to the radio.
The negative supply of the Aprisa SR power connection is internally connected to the Aprisa SR enclosure.
Power must be supplied from a Negative Earthed power supply.
Wire your power source to power connector and plug the connector into the radio. The connector screws
can be fastened to secure the connector.
Additional Phoenix Contact 4 pin female power connectors can be ordered from 4RF:
Part Number
Part Description
APSA-CPH4-FEM-01
4RF Aprisa SR Acc, Connector, Phoenix 4 pin, Female, 1 item
Turn your power source on.
All the radio LEDs will flash orange for one second and then the OK, DATA and CPU LEDs will light green,
the RF LED will light orange and the AUX LED will be off.
The Aprisa SR radio is ready to operate.
The RF LED will light green when the radio is registered with the FAN.
If the LEDs fail to light, carefully check the supply polarity. If the power supply connections have been
accidentally reversed, internal fuses will have blown to protect the unit.
Spare fuses are contained within the radio, see ‘Spare Fuses’on page 55 for instructions on how to locate
and replace the fuses.
External Power Supplies
The following external power supplies are available from 4RF as accessories:
Part Number
Part Description
APSA-P230-030-24-TS
4RF Aprisa SR Acc, PSU, 230 VAC, 30W, 24 VDC, -10 to +60C
APSA-P230-048-24-TE
4RF Aprisa SR Acc, PSU, 230 VAC, 48W, 24 VDC, -20 to +75C
APSA-P230-060-24-TS
4RF Aprisa SR Acc, PSU, 230 VAC, 60W, 24 VDC, -10 to +60C
APSA-P48D-050-24-TA
4RF Aprisa SR Acc, PSU, 48 VDC, 50W, 24 VDC, 0 to +50C