Canon imageCLASS MF5600 Series Service Manual - page 121
Chapter 3
3-65
3.2.5.11
Removing the LCD
Cover
0002-7787
1) Insert a precision flattop screwdriver, etc. onto the
claws [2] in the rear (both sides) of the LCD cover
[1] to disengage the claws to remove the LCD
cover.
F-3-281
3.2.5.12
Removing the
Operation Panel Unit
0002-7789
1) Remove the two screws [1].
2) Disengage the claw [3] on the rear right side of the
operation panel unit [2] and lift it up. After
removing the two flat cables, remove the operation
panel unit.
F-3-282
3.2.5.13
Removing the Scanner
Cover Unit
0002-7791
1) Remove the platen glass cover.
2) Remove the three screws [1].
3) Disengage the front claw [2] and the three claws on
the sides [3]. Lift up the scanner cover unit [4] a
little to disengage the other two claws [5]. Then
remove the scanner cover unit.
F-3-283
3.2.5.14
Removing the Flatbed
Motor Unit
0002-7792
1) Remove the two screws [1].
2) While watching the CCD unit drive belt [2]
carefully, remove the flatbed motor unit [3].
F-3-284
[1]
[2]
[1]
[2]
[3]
[3]
[5]
[4]
[3]
[1]
[1]
[2]
[3]
[1]
[2]