Canon imageCLASS MF5600 Series Service Manual - page 133
Chapter 3
3-77
3.5.2.12
Removing the Power
Supply Shield Plate
0003-7586
1) Remove the five screws [1] to remove the power
supply shield plate [2].
F-3-330
3.5.2.13
Removing the Power
Supply Assembly
0006-3672
1) Remove the three screws [1]. (The external cover is
omitted from the illustration below to show the
instructions clearly.)
2) Remove the four connectors [2] as well as the flat
cable [3] on the DCNT board.
F-3-331
3) As you remove the bosses on both sides [1], lower
the front part of the power supply assembly [2].
Then pull it to remove the power supply assembly.
F-3-332
3.5.2.14
Removing the Cassette
Pickup Solenoid
0006-3673
1) Place the main unit down on its front face (so that
the interior of the main unit is easily visible).
2) Remove the connector [1] on the DCNT board and
take out the cable from the cable guide.
3) Remove the screw [2] to remove the cassette pickup
solenoid [3], which is located behind the main
motor.
F-3-333
3.5.3
Cassette Separation Pad
3.5.3.1
Removing the Cassette
0002-4296
1) Remove the cassette by holding the cassette handle.
3.5.3.2
Removing the Rear of
the Cassette
0002-3783
1) Lift the rear of the cassette, and separate the rear
from the front.
[1]
[2]
[1]
[2]
[2]
[1]
[3]
[1]
[2]
[1]
[2]
[3]