Canon imageCLASS MF5600 Series Service Manual - page 156
Chapter 3
3-100
3.6.1.15
Removing the Left
Frame
0002-7479
1) Remove the cable [1] out of the cable guide.
2) Remove the three screws [2] and then removes the
left frame [3].
F-3-430
3.6.1.16
Removing the Power
Supply Shield Plate
0003-7594
1) Remove the five screws [1] to remove the power
supply shield plate [2].
F-3-431
3.6.1.17
Removing the Fixing
Film Unit
0006-3727
1) Remove the two screws [1] and take off the Fixing
cover [2].
F-3-432
2) Remove the two screws [1]. Remove the Fixing
entrance guide [2] by sliding it sideways back and
forth.
F-3-433
3) Disengage the connector [1] of the power supply
board.
4) Remove the grounding springs and the pressure
springs [2] on both sides.
5) Remove the pressure plates [3] on both sides.
F-3-434
[3]
[2]
[2]
[1]
[1]
[1]
[2]
[1]
[2]
[1]
[2]
[1]
[2]
[2]
[3]