Canon imageCLASS MF5600 Series Service Manual - page 132
Chapter 3
3-76
3.5.2.9
Removing the NCU
Case
0006-3669
1) Remove the three screws [1]; then, pull the upper
portion of the NCU case [2] toward you, and lifting
it upward, remove the NUC case.
F-3-325
3.5.2.10
Removing the Scanner
Unit
0006-3670
1) Remove the screw [1] and remove the connector [2]
as well as the flat cable [3] on the DCNT board.
Remove the tape holding the cable in advance.
Prepare a new tape (Part No: AZ7-0008) of a suitable
length before you attach the cable again.
F-3-326
2) Remove the two front screws [1].
F-3-327
3) Remove the two screws on the back [1]. Slide the
scanner unit [2] to the back; then, remove it by
lifting it.
F-3-328
3.5.2.11
Removing the Plate
0006-3671
1) Remove the connector [1] of the DCNT board.
2) Remove the three screws [2] and then removes the
plate [3].
F-3-329
[1]
[2]
[2]
[1]
[3]
[1]
[2]
[1]
[1]
[2]
[3]