Canon imageCLASS MF5600 Series Service Manual - page 87
Chapter 3
3-31
3.1.16.8
Removing the NCU
Board and Modular Board
0006-3042
1) Remove the two connectors [1] and the flat cable
[2].
2) Remove the four screws [3] and remove the NCU
board [4] and modular board [5].
F-3-130
3.1.16.9
Removing the NCU
Case
0006-3031
1) Remove the three screws [1]; then, pull the upper
portion of the NCU case [2] toward you, and lifting
it upward, remove the NUC case.
F-3-131
3.1.16.10
Removing the
Scanner Unit
0006-3030
1) Remove the screw [1] and remove the connector [2]
as well as the flat cable [3] on the DCNT board.
Remove the tape holding the cable in advance.
Prepare a new tape (Part No: AZ7-0008) of a suitable
length before you attach the cable again.
F-3-132
2) Remove the two front screws [1].
F-3-133
3) Remove the two screws on the back [1]. Slide the
scanner unit [2] to the back; then, remove it by
lifting it.
F-3-134
[1]
[4]
[3]
[3]
[2]
[5]
[3]
[1]
[2]
[2]
[1]
[3]
[1]
[2]
[1]