Canon imageCLASS MF5600 Series Service Manual - page 125
Chapter 3
3-69
3) Remove the two screws on the back [1]. Slide the
scanner unit [2] to the back; then, remove it by
lifting it.
F-3-298
3.3.1.11
Removing the Top
Cover and Left Front Cover
0006-3028
1) Remove the two screws [1].
2) Remove the connector [2] of the DCNT board.
3) Remove the two claws [3] and remove the top cover
[4].
4) Remove the two screws [5] and then removes the
left front cover [6].
F-3-299
3.3.1.12
Removing the Laser/
Scanner Unit
0006-3029
1) Remove the connector [1] of the DCNT board.
Take the cable off the cable clamp. (The external
cover is omitted from the illustration below to show
the instructions clearly.)
2) Take the flat cable [2] off the board of the laser/
scanner unit.
3) Remove the four screws [3] to remove the laser/
scanner unit [4]. Ensure that the grounding plate
[5] does not get lost.
F-3-300
[2]
[1]
[1]
[2]
[4]
[3]
[5]
[6]
[1]
[2]
[3]
[4]
[5]