Canon imageCLASS MF5600 Series Service Manual - page 237
Chapter 5
5-43
5.6.6.1.2
Test Mode Flowchart
0006-5853
To operate the test mode, after pressing the Menu key, press the # key and select "SERVICE MODE". After this,
select "TEST MODE" with the cursor keys, and press the OK key.
Turn OFF and back ON the power to end the Test Mode.
F-5-10
If the machine is returned to standby mode with the Menu key after the Test Mode is ended, it fails to be reset,
leading to malfunction during communication.
Therefore, be sure to turn OFF and back ON the power after the Test Mode is ended.
[1] DRAM TEST
[2] SCAN TEST
[3] PRINT TEST
[4] MODEM TEST
[5] AGING TEST
[6] FUNCTION TEST
[1] DRAM TEST
[2] DRAM TEST
[1] WHT
[2] BLK
[3] STRPS
[4] CHKRS
[5] CHKRS2
[6] ENDUR
[7] BK/WHT
[8] BIAS
[9] CHKRS3
[1] RELAY TEST
[2] FREQ TEST
[4] G3 SIGNAL Tx TEST
[5] DTMF TEST
[6] MODEM TEST
[8] G3 V34 Tx TEST
[1] G3 4800bps TEST
[3] SENSOR
[4] ADF FEED TEST
[5] BOOK FEED TEST
[6] SPEAKER
[7] OPERATION PANEL
[8] LAMP TEST
[9] LINE TEST
TEST MODE
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
‘
*
’ indicates that these items
are not used in the field.