D-Link DXS-1100 series User Manual - page 100
D-Link 10 Gigabit Ethernet Switch User Manual
9
9
3
3
Trap State: Enable or disable port security traps on the Switch.
Trap Rate: Enter the number of traps per second. The range is from 0 to 1000. The default value 0 indicates
an SNMP trap to be generated for every security violation.
System Maximum Address: Enter the maximum number of secure MAC addresses allowed. If not specified,
the default value is No Limit. The valid range is from 1 to 6656. Tick No Limit to allow the maximum number
of secure MAC address.
Click Apply to accept the changes made for each individual section.
Security > Port Security > Port Security Port Settings
This window is used to view and configure the port security port settings.
Figure 4.133 – Security > Port Security > Port Security Port Settings
The fields that can be configured are described below:
From Port / To Port: Select the appropriate port range used for the configuration here.
State: Enable or disable the port security feature on the port(s) specified.
Maximum: Enter the maximum number of secure MAC addresses that will be allowed on the port(s)
specified. This value must be between 0 and 64. By default, this value is 32.
Violation Action: Select the violation action that will be taken here. Options to choose from are Protect,
Restrict, and Shutdown.
Protect - Drop all packets from the insecure hosts at the port-security process level, but does not
increment the security-violation count.
Restrict - Drop all packets from the insecure hosts at the port-security process level and increments
the security-violation count and record the system log.
Shutdown - Shut down the port if there is a security violation and record the system log.
Security Mode: Select the security mode option here. Options to choose from are Permanent and Delete-
on-Timeout.
Permanent - All learned MAC addresses will not be purged out unless the user manually deletes
those entries.
Delete-on-Timeout - All learned MAC addresses will be purged out when an entry is aged out or
when the user manually deletes these entries.
Aging Time: Enter the aging time value used for auto-learned dynamic secured addresses on the specified
port here. This value must be between 0 and 1440 minutes.