D-Link DXS-1100 series User Manual - page 57
D-Link 10 Gigabit Ethernet Switch User Manual
5
5
0
0
Figure 4.65 – Management > File System (Search for Drive)
Click Previous to return to the previous window.
Click Create Directory to create a new directory within the file system of the Switch.
Click Copy to copy a specific file to the Switch.
Click Boot Up to set a specific file as either the boot-up image or boot-up configuration.
Click Rename to rename a specific file’s name.
Click Delete to remove a specific file from the file system.
Click Copy to see the following window.
Figure 4.66 – Management > File System (Copy)
When copying a file to the file system of this switch, the user must enter the Source and Destination path.
Tick Replace to replace the current running configuration with the indicated configuration file.
Click Apply to initiate the copy.
Click Cancel the discard the process.
NOTE: / \ : * ? " < > | and space are not allowed
in the file name.
NOTE: When renaming the file or folder name,
or creating a directory, the forward slash
character (/) is used to indicate the file or folder
path except if the forward slash character is used
at the end of the file name in which it is then
considered to be part of the file name thus, in
this usage, the forward slash character would not
be allowed.
Management > D-Link Discovery Protocol
This window is used to configure and display D-Link Discovery Protocol (DDP).