D-Link DXS-1100 series User Manual - page 80
D-Link 10 Gigabit Ethernet Switch User Manual
7
7
3
3
The fields that can be configured are described below:
Minimum Version: Select the minimum version of MLD hosts that is allowed on the VLAN.
Querier State: Enable or disable the querier state.
Query Version: Select the general query packet version sent by the MLD snooping querier. Options to
choose from are 1 and 2.
Query Interval: Enter the interval at which the MLD snooping querier sends MLD general query messages
periodically.
Max Response Time: Enter the maximum response time, in seconds, advertised in MLD snooping queries.
The range is 1 to 25.
Robustness Value: Enter the robustness variable used in MLD snooping.
Last Member Query Interval: Enter the interval at which the MLD snooping querier sends MLD group-
specific or group-source-specific (channel) query messages.
Rate Limit: Enter the MLD snooping rate limit used. Tick No Limit to ignore the rate limit.
Click Apply to accept the changes made.
Click the X button at the upper-right side to close the window.
L2 Features > L2 Multicast Control> MLD Snooping > MLD Snooping Groups Settings
This window is used to configure and view the MLD snooping static group, and view MLD snooping group.
Figure 4.102 – L2 Features > L2 Multicast Control > MLD Snooping > MLD Snooping Groups Settings
The fields that can be configured are described below:
VID: Enter a VLAN ID of the multicast group.
Group Address: Enter an IPv6 multicast group address.
From Port / To Port: Select the appropriate port range used for the configuration here.
VID: Click the radio button and enter a VLAN ID of the multicast group.
Group Address: Click the radio button and enter an IP multicast group address.
Click Apply to accept the changes made.
Click Delete to remove the specified entry.
Click Find to locate a specific entry based on the information entered.
Click Find All to view all the entries.
Enter a page number and click Go to navigate to a specific page when multiple pages exist.