D-Link DXS-1100 series User Manual - page 71
D-Link 10 Gigabit Ethernet Switch User Manual
6
6
4
4
Figure 4.90 – L2 Features > Loopback Detection
The fields that can be configured are described below:
Loopback Detection State: Enable or disable loopback detection. The default is Disabled.
Mode: The loopback detection mode is Port-based.
Traps State: Select to enable or disable the loopback detection trap state.
Interval: Enter the interval in seconds that the device will transmit all the CTP (Configuration Test Protocol)
packets to detect a loop-back event. The valid range is from 1 to 32767 seconds. The default setting is 10
seconds.
From Port / To Port: Select the appropriate port range used for the configuration here.
State: Enable or disable the state of the port.
Click Apply to accept the changes made for each individual section.
L2 Features > Link Aggregation
Understanding Port Trunk Groups
Port trunk groups are used to combine a number of ports together to make a single high-bandwidth data
pipeline.
The DXS-1100-10TS supports up to 5 port trunk groups with 1 to 4 ports in each group. The DXS-1100-
16TC supports up to 8 port trunk groups with 1 to 8 ports in each group.