D-Link DXS-1100 series User Manual - page 13
D-Link 10 Gigabit Ethernet Switch User Manual
6
6
Fans: Switches in this series have a built-in temperature sensor that will measure the switch’s internal
temperature and then automatically adjust the speed of the fans to either high-speed or low-speed.
DXS-1100-16TC
The DXS-1100-16TC 10 Gigabit Ethernet Switch supports the following ports:
• Twelve 100/1000/10000Mbps copper Ethernet ports.
• Two 100/1000/10000Mbps copper, 1/10Gbps SFP+ combo ports
• Two 1/10Gbps SFP+ module ports.
Front Panel
Figure 1.4 – DXS-1100-16TC Front Panel
Power LED
: The Power LED lights up when the Switch is connected to a power source.
Port Link/Act/Speed LED (1-16): The Link/Act/Speed LED flashes, which indicates a network link through
the corresponding port. Blinking indicates that the Switch is either sending or receiving data to the port.
When a port has an amber light, this indicates that the port is running on 100M or 1000M. When it has a
green light it is running on 10G.
Fan Err: The LED illuminates red when the fan has run time failure and is brought offline.
Reset: By pressing and holding the Reset button inside the pinhole for 3 to 5 seconds, the Switch will
change back to the default configuration and all changes will be lost.
Rear Panel
Figure 1.5 – DXS-1100-16TC Rear Panel
Power: The power port is where to connect the AC power cord.
Security Lock: Provide a Kensington-compatible security lock to be able to connect to a secure immovable
device. Insert the lock into the notch and turn the key to secure the lock. The lock-and-cable apparatus
should be purchased separately.
Switch GND: Use an electrical grounding wire and connect one end of the wire to the Switch GND and the
other end of the wire to an electrical grounding point most commonly found on the switch mounting rack itself.
Side Panels
Figure 1.6 – DXS-1100-16TC Side Panels
Heat Vents: The heat vents are used to dissipate internal heat and facilitate internal air circulation. Do not
block these openings. Leave at least 6 inches of space at the rear and sides of the Switch for proper